Norco Transmission Jack with a 1.5-ton capacity features a lift height from 4-3/4" to 36-1/2" and is made in the USA. Similar to model 72000E floor-use jacks, this model is designed to handle heavy truck transmissions and is ideally suited for truck dealers, maintenance work, and heavy-duty transmission repair centers, but Norco's new transmission jack has a wider chassis opening and both lower and higher lift heights to handle a larger variety of transmission configurations than the 72000E. This unit features a fully-adjustable saddle (20 front and back and 11 side-to-side) with adjustable angle brackets to position the transmission, and four heavy-duty ratchet tie-downs conveniently secure the load to the lifting saddle. This unit also includes a safety by-pass system to protect the pressure cylinder, a safety overload system to prevent the jack from being used beyond its rated capacity, and a flash-chromed ram to stop rust from entering the hydraulic system. The unit's 360-rotating handle operates in any position, and four full-swivel, ball-bearing caster wheels allow for easy positioning. This jack also features four 4-high riser tubes to handle transmissions with offset transfer cases. Note: Freight charges for this product will be calculated after order is placed, and we will contact you with the amount. Please call if freight quote is desired before ordering. Norco charges a limited access fee for shipments to military bases, schools, churchs, and all other gated areas, as well as charging a substantial fee for re-delivery of order, lift gate use, and residential delivery. Also, local sales taxes will be applied to ALL Norco orders shipped to California.